



I stamped the flowers on printed papers, then cut out a few layers and mounted each layer with the smallest foam dot I had. I punched a 1/8" hole on each side and tied a ribbon for a handle.

The pattern was a bit too large to fit in my scanner...so, here are a few simple instructions:

Start with an 8" x 9-3/8" piece of vellum/paper...score at 3-1/2" from each side (see photo, above). Cut along the 4 solid lines as shown below:

Next cut 1/4" away from the vertical dotted lines (as indicated by the solid vertical lines, below):

This is how your finished pattern should look:

Fold along the dotted lines and apply double stick tape to the 4 tabs to complete your favor. Now all you have to do is figure out what to put on the inside!!!
2 comments:
Ohhh, these are so pretty.
Jean = love your creativity...
You really have some pretty crafts you always share with everyone...
love it!
Post a Comment